The aircraft manufacturer introduced by design change installation of the Facet 478360 / Facet 476087E electric fuel pump in the fuel system. By installing this pump, it is possible to reduce the contingent oscillation of fuel pressure.
Consolidated procedure for coolant check, adapted the procedure of use parking brake due to the installation of brake system with Beringer components, updated heating/ventilating system, added supplement No. 42 and 43 into List of Supplements.
The aircraft manufacturer introduced by design change installation of the Facet 478360 / Facet 476087E electric fuel pump in the fuel system. By installing this pump, it is possible to reduce the contingent oscillation of fuel pressure.
Addition of Supplement No. 39, 40, 41 into List of Supplements in Section 9 of the Pilot’s Operating Handbook doc. No. ERTC020-10-AS for SPORTSTAR RTC.
Unification of the strength class of the fastening bolts in the joint of the engine and the engine mount hinges and the resulting minimization of the possibility that these bolts will be accidentally interchanged
Installation of DUC SWIRL-3-L propeller according to EASA Major Change Approval 10080106 instead of standard installed propeller Woodcomp Klassic 170/3/R.
When installing, replacing or repairing the brake caliper bodies, the brake caliper cuff may be fitted incorrectly, which may cause the brake system to malfunction.
Issue of Revision No. 1 of Supplement No. 37 of POH, doc. no. ERTC020-10-AS-037, which contains a clarification of the propeller blade pitch setting value
When installing, replacing or repairing the brake caliper bodies, the brake caliper cuff may be fitted incorrectly, which may cause the brake system to malfunction.
The engine manufacturer (ROTAX) has issued Service Bulletin
SB-912-076UL ordering the replacement of the fuel pump
nipple fittings. The reason for the replacement is the fact that a
certain number of fuel pump nipple fittings were installed using
a lubricant instead of the prescribed thread sealant LOCTITE
577 Yellow.
Increasing the safety of the oil system of THE ROTAX
912 ULS2 / S2 series engines by installing the PYROJACKET
PJA 14 protective sleeves on the oil system hoses.
Due to a deviation in the manufacturing process some tailpipe of muffler may have anomalies in the welded joint. In some cases, there is possibility that cracks may occur on a limited number of muffler tailpipe. Undetected cracks during Pre-flight Check may result in a loss of tailpipe.
In airplanes mentioned in this bulletin, heat damage of the lower engine cowling in the place of the reinforcement may occur as a result of proximity to the exhaust elbow of cylinder No. 1 and No.2. The revision of the bulletin changes the type of fire-protection paint.
Manufacturers of the SkyView (Dynon) and G3X (Garmin) systems have issued service bulletins (Dynon Service Bulletin 050620E, Garmin 2069 Rev. A), whereby prescribe the inspection of Kavlico P/N P4055-15G-E4A, P4055-50G-E4A nebo P4055-150G-E4A fluid pressure sensors.
The aircraft manufacturer introduced by a design change - installation of the TOST PVZ parking brake valve in the brake system. The installation solves problem with the manufacturer of the GoldFren parking valve.
The aircraft manufacturer introduced a design change - installation of the VDO A2C59510165 fuel level sensor in the fuel system. By installing this sensor, it is possible to reduce the unstable values during measuring the fuel level.
The aircraft manufacturer introduced by design change installation of the Facet 478360 electric fuel pump in the fuel system. By installing this pump, it is possible to reduce the contingent oscillation of fuel pressure.
The aircraft manufacturer introduced by an option design change installation of the TC1-9073-06-01 pulsation damper in the fuel system. By installing the pulsation damper, it is possible to reduce the contingent oscillation of fuel pressure below the lower limit (for more than 5 sec.).
The aircraft manufacturer introduced by an option design change installation of the TC1-9073-06-01 pulsation damper in the fuel system. By installing the pulsation damper, it is possible to reduce the contingent oscillation of fuel pressure below the lower limit (for more than 5 sec.).
Addition of Supplements No. 34, 35, 36 into List of Supplements in Section 9 of the Pilot’s Operating Handbook doc. No. ERTC020-10-AS for SPORTSTAR RTC.
The engine manufacturer issued SB-912-063R1 and SB-912-
063ULR2 service bulletins regarding the replacement of fuel pumps. After replacement of the original fuel pumps p/n 892542 and 892546 for the pump p/n 893110, this fuel pump can be contacted with the engine cowlings
Inspection of passage of cables of the external power source
through the fire wall.
In case of insufficient inspection of cables of the external power source in the area of passage through the fire wall, the bushing may be damaged, and the cable may contact the fire wall
Based on operational experience, the airplane manufacturer has decided to refresh general procedures during taxiing, takeoff and landing with crosswind.
The engine manufacturer orderes by the bulletins SB-912-070 R1 and SB-912-070UL, inspection and / or replacement of the valve push rod assy., and rocker arm. Due to deviations in the manufacturing of the valve push rod assy., partial wear on the rocker arm ball socket may occur. This wear might lead to a rocker arm cracking / fracture which consequence may lead to a malfunction of the valve train. Possible effect are rough engine running or an unusual engine operating behaviour.
Clarification of engine idle RPM, added information on throttle lever operation, added information to section 7 and added supplements No. 25 and 26 into List of Supplements in Section 9.
When the Dynon SkyView system and the radio station are switched on, the symbol RX on the radio station display may flash or stay lit even if the radio station does not receive transmission of other radio stations.The characteristic sound of open SQUELCH, or other disturbing noises (tones) are heard in the headphones.It is not possible to correct this interference by reducing the sensitivity of the radio station to the minimum level.The interference is caused by the SV-250-GPS antennas.
Install of the Winterization Kit in accordance with document No. ERTC022-10-AS-003 Supplement No. 3. Installation of the Winterization Kit. Insert document No. ERTC022-10-AS-003 in the Maintenance Manual (AMM). Record implementation of this bulletin in Airplane Log Book.
Low oil temperature during winter operation.
Operating oil temperature is reached sooner when thermostat is installed.
Revision specifies only the working procedure. It does not affect the installation
The engine manufacturer orders by the above mentioned bulletins to exchange of carburetors floats on engines. All engines which have been equipped with floats and/or carburetors during engine repair, maintenance or general overhaul, as well.
Insertion of information on installation of the new adjustable foot pedals. Added limitation of electrical system and supplements No. 22 and 23 into List of Supplements in Section 9, minor corrections.
The engine manufacturer orders by the above mentioned bulletins to measure temperature of coolant instead of cylinder head temperature with the engines with the design change of cylinder heads. In accordance with the revision of Service Instruction SI-912-016 R8 it is not allowed to use waterless coolant for these engines.
By clicking “Accept All Cookies”, you agree to the storing of cookies on your device to enhance site navigation, analyze site usage and assist in our marketing efforts. More info